Merck
  • The iron-based phosphate binder PA21 has potent phosphate binding capacity and minimal iron release across a physiological pH range in vitro.

The iron-based phosphate binder PA21 has potent phosphate binding capacity and minimal iron release across a physiological pH range in vitro.

Clinical nephrology (2014-03-25)
Maria Wilhelm, Sylvain Gaillard, Viatcheslav Rakov, Felix Funk
RESUMO

Hyperphosphatemia in advanced chronic kidney disease (CKD) necessitates the use of phosphate binders. This in vitro study assessed phosphate binding and Fe release properties of the novel iron-based phosphate binder PA21. Phosphate adsorption and Fe release were assessed under conditions simulating administration of PA21 on an empty stomach and full stomach across a pH range to which PA21 would be exposed during passage through the gastrointestinal (GI) tract. PA21 showed a robust phosphate binding capacity over the entire physiologically relevant pH range. The high binding capacity at low pH indicates that phosphate binding could begin in the stomach. Under the current experimental setting, the maximal bound phosphate to Fe ratio was 0.47 mmol P/mmol Fe. The largest amount of Fe release was observed at the lowest pH without phosphate and was much lower in the presence of phosphate. These results are in line with the formation of iron phosphate at low pH, as indicated by X-ray photoelectron spectroscopy and thermodynamic calculations. Fe release was minimal (≤ 0.35%) across pH 2.5 - 8.5. These studies demonstrate that PA21 has potent phosphate binding capacity and low iron release over a physiologically relevant pH range in the GI tract. These features indicate PA21 could be an effective alternative phosphate binder for CKD patients.

MATERIAIS
Número do produto
Marca
Descrição do produto

Sigma-Aldrich
Iron, ≥99%, reduced, powder (fine)
Sigma-Aldrich
Carbonyl iron, ≥97% Fe basis
Sigma-Aldrich
Iron, granular, 10-40 mesh, >99.99% trace metals basis
Sigma-Aldrich
Iron, puriss. p.a., carbonyl-Iron powder, low in magnesium and manganese compounds, ≥99.5% (RT)
Sigma-Aldrich
Iron, chips, 99.98% trace metals basis
Sigma-Aldrich
Iron, foil, thickness 0.1 mm, ≥99.9% trace metals basis
Sigma-Aldrich
Iron, wire, diam. 1.0 mm, ≥99.9% trace metals basis
Sigma-Aldrich
Iron, foil, thickness 0.25 mm, ≥99.99% trace metals basis
Iron, rod, 100mm, diameter 100mm, as drawn, armcO« soft ingot 99.8%
Iron, IRMM®, certified reference material, 0.5 mm wire
Iron, foil, 100x100mm, thickness 0.125mm, as rolled, 99.99+%
Iron, rod, 100mm, diameter 2.0mm, as drawn, 99.95%
Iron, foil, 15mm disks, thickness 0.0125mm, 99.99+%
Iron, foil, 10mm disks, thickness 0.01mm, 99.85%
Iron, rod, 1000mm, diameter 2.0mm, as drawn, 99.95%
Iron, foil, 4mm disks, thickness 0.005mm, 99.85%
Iron, rod, 500mm, diameter 4.8mm, as drawn, 98+%
Iron, foil, 25mm disks, thickness 0.003mm, 99.85%
Iron, foil, 300x300mm, thickness 3.0mm, as rolled, 99.5%
Iron, foil, 15mm disks, thickness 0.004mm, 99.99+%
Iron, foil, 150x150mm, thickness 0.125mm, hard, 99.5%
Iron, foil, 15mm disks, thickness 0.008mm, 99.85%
Iron, foil, light tested, 100x100mm, thickness 0.015mm, 99.85%
Iron, foil, not light tested, 100x100mm, thickness 0.015mm, 99.99+%
Iron, rod, 1000mm, diameter 9.5mm, as drawn, 98+%
Iron, foil, 150x150mm, thickness 1.5mm, as rolled, 99.5%
Iron, rod, 500mm, diameter 19.0mm, as drawn, 98+%
Iron, rod, 50mm, diameter 6.0mm, as drawn, 99.99+%
Iron, foil, 100x100mm, thickness 0.25mm, hard, 99.5%
Iron, foil, 150x150mm, thickness 0.15mm, hard, 99.5%