Certain features of will be down for maintenance Saturday afternoon/evening, February 24th starting at 3:00 pm CT until 9:00 pm CT.

Please note that you still have telephone and email access to our local offices. We apologize for any inconvenience.

mini Quick Spin Oligo Columns Troubleshooting

Product No. 11814397001


Nucleotide contamination of final sample for mini Quick Spin Columns or Quick Spin Columns

Possible reasons are:

  1. Sample should not be applied to the side of the column, so that molecules to flow around the gel matrix; instead the sample should pass through the matrix (for purification).
    Recommendation: Apply sample directly to center of the column bed.
  2. Column is overloaded, which causes nucleotides to flow through the matrix. Recommendation: Apply a sample containing 0.02 - 1.0 mg/ml nucleic acid. Apply no more than 50 μl sample to a G-25 column, no more than 100 μl to a G-50 column.
  3. The incorrect g-force was used during centrifugation: Column matrix may collapse and unincorporated nucleotides may pass freely through the column.
    Recommendation: Use 1100 x g for centrifugation spins. Be sure that centrifuge is correctly calibrated.
  4. The incorrect rotor was used in the centrifuge.
    Recommendation: Use swinging-bucket rotor. A fixed-angle rotor may cause nucleotide contamination of final sample.
  5. Column was vortexed too long or too vigorously during matrix resuspension: Recommendation:
  • Do not vortex column longer than 5 seconds.
  • Vortex the column at low speed only.
  • Do not use medium or high speed.

Poor sample recovery of mini Quick Spin Column or Quick Spin Column

Possible reasons for poor sample recovery:

  1. Centrifugation speed too fast or centrifugation time too short: Do not centrifuge the columns faster than recommended speed.
  2. Matrix not evenly resuspended prior to packaging step: To fully resuspend the matrix before packing step, do one of the following:
    - Invert column vigorously several times and flick the column sharply to help resuspending the matrix
    - Vortex column gently (5 seconds or less, at low speed)
  3. The column was tipped on its side, which causes backflow of sample and reduced nucleic acids recovery: Keep the column upright during and after application of sample, especially after centrifugation.
  4. Sample volume is too small (<20 μl): Do one of the following:
    - Add 1 x STE buffer to sample until total sample volume is 20 μl
    - After applying sample add 1x STE buffer to the matrix. Total volume applied (sample + STE buffer) must not be greater than the maximum sample volume recommended for the column.
    - At < 0.02 mg/ml DNA/RNA recovery may be low. To improve recovery of diluted samples, add carrier (glycogen, tRNA or sperm DNA) to sample.
  5. There is too much sample. At > 1.0 mg/ml, the sample is viscous and may not migrate through the columns easily, leading to poor recovery and / or contamination with smaller molecules.


Related Links