MCSL30S01

Durapore^® 5,0 µm, Cartucho Millidisk^®

Millidisk^® 30, filtration area 1500 cm², hydrophilic

• Sinónimos: Millidisk Cartridge 30-stack 5.0 μm Hydrophilic
• Código UNSPSC: 23151806
• eCl@ss: 32031690

Propiedades

• Materiales: PVDF ; polysulfone ; polysulfone support; silicone seal
• Nivel de calidad: 400
• esterilidad: non-sterile
• Compatibilidad de esterilización: autoclavable compatible; steam-in-place compatible
• Línea del producto: Millidisk^® 30
• Características: hydrophilic
• fabricante / nombre comercial: Millidisk^®
• Parámetros: 0.35 bar max. differential pressure (5 psid) at 123 °C (Forward); 0.35 bar max. inlet pressure (5 psi) at 123 °C (Forward); 0.7 bar max. differential pressure (10 psid) at 25 °C (Reverse); 0.7 bar max. inlet pressure (10 psi) at 25 °C (Reverse); 1.7 bar max. differential pressure (25 psid) at 80 °C (Forward); 1.7 bar max. inlet pressure (25 psi) at 80 °C (Forward); 4.1 bar max. differential pressure (60 psid) at 25 °C (Forward); 4.1 bar max. inlet pressure (60 psi) at 25 °C (Forward); 75 L/min flow rate at 2.1 bar (ΔP)
• técnicas: prefiltration: suitable
• filtración área: 1500 cm²
• impurezas: ≤0.5 EU/mL bacterial endotoxins (LAL test, Aqueous extraction); <0.5 EU/mL USP bacterial endotoxins (LAL test, sample aqueous extraction)
• extraíbles gravimétricos: ≤7.5 mg/device
• Matriz: Durapore^®
• tamaño de poro: 5.0 μm pore size
• entrada: sample type liquid
• punto de burbuja: ≥138 mbar (2 psig), air with water at 23 °C
• código del cartucho: not applicable

Descripción

Descripción general

Device Configuration: Cartridge

Stack Design: 30 Stak

Envase

Double Easy-Open bag

Nota de preparación

Sterilization Method
5 SIP cycles of 60 min @ 135 °C; 5 autoclave cycles of 60 min @ 126 °C

This product was manufactured with a Durapore^® membrane which meets the criteria for a "non-fiber releasing" filter as defined in 21 CFR 210.3 (b) (6).

Nota de análisis

Gravimetric Extractables: using sterilized device after 24 hours in water at controlled room temperature

Will meet the USP Oxidizable Substances Test requirements after a water flush of ≥200 mL

Otras notas

Directions for Use

• Organism Retention: Microorganism
• Mode of Action: Filtration (size exclusion)
• Application: BioProcessing
• Intended Use: Reduction or removal of microorganism/bioburden
• Instructions for Use: Please refer Wetting Instructions for Filter Units with Durapore^® Membrane user guide
• Storage Statement: Store in dry location
• Disposal Statement: Dispose of in accordance with applicable federal, state and local regulations.

These products are manufactured in a facility which adheres to FDA Good Manufacturing Practices.

Información legal

Durapore is a registered trademark of Merck KGaA, Darmstadt, Germany

MILLIDISK is a registered trademark of Merck KGaA, Darmstadt, Germany