Analytical performance of three commonly used extraction methods for the gas chromatography-mass spectrometry analysis of wine volatile compounds.

Analytical performance of three commonly used extraction methods for the gas chromatography-mass spectrometry analysis of wine volatile compounds.

Journal of chromatography. A (2009-09-08)

I Andujar-Ortiz, M V Moreno-Arribas, P J Martín-Alvarez, M A Pozo-Bayón

PMID19732903

ZUSAMMENFASSUNG

The analytical performance of three extraction procedures based on cold liquid-liquid extraction using dicloromethane (LLE), solid phase extraction (SPE) using a styrene-divinylbenzene copolymer and headspace solid phase microextraction (SPME) using a carboxen-polydimethylsiloxane coated fibre has been evaluated based on the analysis of 30 representative wine volatile compounds. From the comparison of the three procedures, LLE and SPE showed very good linearity covering a wide range of concentrations of wine volatile compounds, low detection limits, high recovery for most of the volatile compounds under study and higher sensitivity compared to the headspace-SPME procedure. The latter showed in general, poor recovery for polar volatile compounds. Despite some drawbacks associated with the LLE and SPE procedures such as the more tedious sampling treatment and the use of organic solvents, the analytical performance of both procedures showed that they are more adequate for the analysis of wine volatiles.

MATERIALIEN

Produktnummer

Marke

Produktbeschreibung

57298-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, StableFlex (1 cm), needle size 23 ga, Autosampler, pk of 3, plain gray hub

57348-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, StableFlex (2cm), needle size 24 ga, Autosampler, pk of 3, notched gray hub

57328-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, StableFlex (1cm), needle size 24 ga, Manual Holder, pk of 3, plain gray hub

57299-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, StableFlex (2cm), needle size 23 ga, Autosampler, pk of 3, notched gray hub

57329-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, StableFlex (1 cm), needle size 24 ga, Autosampler, pk of 3, plain gray hub

20358

Supelco

ORBO^™ Carboxen-564 Röhrchen, W,F,F separators, O.D. × L 6 mm × 75 mm, pkg of 25 ea, for analyte group MEK (methylethyl ketone)

20355

Supelco

ORBO^™ 78 HBr auf Carboxen^® 564 speziell gereinigt (20/45), 400/200 mg, W,W,W separators, O.D. × L 6 mm × 110 mm, pkg of 25 ea

25467

Supelco

Carboxen^®-1010 PLOT Kapillar-GC-Säule, L × I.D. 30 m × 0.53 mm, average thickness 30 μm

10478-U

Supelco

Carboxen^® Adsorptionsmittel, matrix Carboxen^® 1000, 60-80 mesh, bottle of 10 g

57318

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 24 ga, Manual Holder, pk of 3, black hub

25461

Supelco

Carboxen^®-1006 PLOT Kapillar-GC-Säule, L × I.D. 30 m × 0.53 mm, average thickness 30 μm

57319

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 24 ga, Autosampler, pk of 3, black hub

57295-U

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 85 μm CAR/PDMS, StableFlex (1 cm), needle size 23 ga, Autosampler, pk of 3, light blue hub

24246

Supelco

Carboxen^®-1010 PLOT Kapillar-GC-Säule, L × I.D. 30 m × 0.32 mm, average thickness 15 μm

57334-U

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 85 μm CAR/PDMS, StableFlex (1 cm), needle size 24 ga, Manual Holder, pk of 3, light blue hub

57335-U

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 85 μm CAR/PDMS, StableFlex (1 cm), needle size 24 ga, Autosampler, pk of 3, light blue hub

23446-U

Supelco

ORBO^™-93 Sorbensröhrchen, ORBO tube I.D. × L 6 mm × 95 mm, Bed A 180 mg, Bed B 90 mg, 60/80 mesh, pkg of 25 ea

57343-U

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 23 ga, Autosampler, pk of 3, black hub

504831

Supelco

Tragbarer SPME-Field-Sampler, coating CAR/PDMS

24241-U

Supelco

Carboxen^®-1006 PLOT Kapillar-GC-Säule, L × I.D. 30 m × 0.32 mm, average thickness 15 μm

28718-U

Supelco

Tenax^® TA / Carboxen^® 1018, glass TD tube, preconditioned, O.D. × L 1/4 in. × 3 1/2 in., Sealed with (Swagelok^® End-Fittings), pkg of 10 ea

57344-U

Supelco

SPME-Faseranordnung Carboxen/Polydimethylsiloxan (CAR/PDMS), 75 μm CAR/PDMS, Fused Silica (1 cm), needle size 23 ga, Manual Holder, pk of 3, black hub

10471

Supelco

Carboxen^® Adsorptionsmittel, matrix Carboxen^® 1003, 40-60 mesh, bottle of 10 g

57914-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, Metal Alloy (2cm), needle size 23 ga, Autosampler, pk of 1, plain gray hub

54294-U

Supelco

Carboxen^® 572 for Tobacco Smoke, Adsorbent Bed Wt: 300 mg, cartridge size 3 mL, pkg of 50 ea

57912-U

Supelco

SPME-Faseranordnung, 50/30µm DVB/CAR/PDMS, Metal Alloy (1cm), needle size 23 ga, Autosampler, pk of, plain gray hub

10269

Supelco

Carboxen^® Adsorptionsmittel, matrix Carboxen^® 569, 20-45 mesh, bottle of 10 g

54041-U

Supelco

Carboxen^® 1000 Reversibles SPE-Röhrchen, 200 mg/mL, pk 30

11072-U

Supelco

Carboxen^® Adsorptionsmittel, matrix Carboxen^® 572, 20-45 mesh, bottle of 10 g

10477-U

Supelco

Carboxen^® Adsorptionsmittel, matrix Carboxen^® 1000, 40-60 mesh, bottle of 50 g