Direkt zum Inhalt
Merck
  • Degradation of sulphamethazine by means of an improved photo-Fenton process involving a hydrogen peroxide systematic dosage.

Degradation of sulphamethazine by means of an improved photo-Fenton process involving a hydrogen peroxide systematic dosage.

Environmental technology (2014-06-25)
Evelyn Yamal-Turbay, Lydia Pérez González, Moisès Graells, Montserrat Pérez-Moya
ZUSAMMENFASSUNG

Despite being acknowledged as an emerging contaminant, sulphamethazine (SMT) degradation has received scarce attention in the advanced oxidation processes field. Thus, this work addresses the degradation of SMT in water solutions (12 L of 25mgL-1 samples) by means of a photo-Fenton process and a systematic H202 dosage protocol that enhances its performance. A conventional photo-Fenton process led to 86% mineralization after 120 min treatment when adding the Fenton reactants at once (initial concentrations were 10mgL-1 Fe(II) and 200mgL-1 H2O2). Conversely, the process achieved the total mineralization of the samples in less than 75 min when the same amount of H202 was continuously dosed according to a conveniently tuned dosage protocol. In both cases, total SMT degradation was achieved within 10 min. Hence, this work's aim is to determine the efficient dosage conditions of H2O2. The results show that a significant improvement of the photo-Fenton mineralization of SMT solutions is possible by adjusting the dosage of H2O2.

MATERIALIEN
Produktnummer
Marke
Produktbeschreibung

Sigma-Aldrich
Wasserstoffperoxid -Lösung, contains inhibitor, 30 wt. % in H2O, ACS reagent
Sigma-Aldrich
Wasserstoffperoxid -Lösung, 30 % (w/w) in H2O, contains stabilizer
Sigma-Aldrich
Wasserstoffperoxid -Lösung, 50 wt. % in H2O, stabilized
Sigma-Aldrich
Eisen, ≥99%, reduced, powder (fine)
Millipore
Wasserstoffperoxid -Lösung, 3%, suitable for microbiology
Supelco
Wasserstoffperoxid -Lösung, ≥30%, for trace analysis
Sigma-Aldrich
Wasserstoffperoxid -Lösung, contains inhibitor, 30 wt. % in H2O, meets USP testing specifications
Sigma-Aldrich
Eisen, granular, 10-40 mesh, >99.99% trace metals basis
Sigma-Aldrich
Carbonyleisen, ≥97% Fe basis
Sigma-Aldrich
Wasserstoffperoxid -Lösung, 34.5-36.5%
Sigma-Aldrich
Eisen, puriss. p.a., carbonyl-Iron powder, low in magnesium and manganese compounds, ≥99.5% (RT)
Supelco
Wasserstoffperoxid -Lösung, 30 % (w/w), for ultratrace analysis
Sigma-Aldrich
Eisen, powder, −325 mesh, 97%
Sigma-Aldrich
Sulfamethazin, 99.0-101.0% (on dried basis)
Sigma-Aldrich
Eisen, chips, 99.98% trace metals basis
Sigma-Aldrich
Eisen, foil, thickness 0.1 mm, ≥99.9% trace metals basis
Sigma-Aldrich
Eisen, wire, diam. 1.0 mm, ≥99.9% trace metals basis
Supelco
Sulfamethazin, VETRANAL®, analytical standard
Sigma-Aldrich
Wasserstoffperoxid -Lösung, tested according to Ph. Eur.
Sigma-Aldrich
Eisen, foil, thickness 0.25 mm, ≥99.99% trace metals basis
Sulfadimidin, European Pharmacopoeia (EP) Reference Standard
Eisen, foil, 100x100mm, thickness 0.25mm, hard, 99.5%
Eisen, foil, 100x100mm, thickness 0.1mm, hard, 99.5%
Eisen, IRMM®, certified reference material, 0.5 mm wire
Eisen, foil, 300x300mm, thickness 0.1mm, hard, 99.5%
Eisen, rod, 100mm, diameter 2.0mm, as drawn, 99.95%
Eisen, rod, 50mm, diameter 40mm, as drawn, armcO« soft ingot 99.8%
Eisen, rod, 200mm, diameter 6.35mm, as drawn, soft ingot 99.8%
Eisen, rod, 200mm, diameter 25mm, as drawn, 98+%
Eisen, tube, 200mm, outside diameter 3.2mm, inside diameter 2.2mm, wall thickness 0.5mm, as drawn, 99.8%