Direkt zum Inhalt
Merck
  • Fast and simultaneous determination of endocrine disrupting compounds by ultra-high performance liquid chromatography-tandem mass spectrometry.

Fast and simultaneous determination of endocrine disrupting compounds by ultra-high performance liquid chromatography-tandem mass spectrometry.

Talanta (2015-12-24)
C Esteve, L Herrero, B Gómara, J E Quintanilla-López
ZUSAMMENFASSUNG

A rapid and sensitive analytical method for the simultaneous determination of thirteen endocrine disruptors (five phthalates, seven parabens, and bisphenol A) in a single chromatographic run has been developed for the first time. The separation method, based on ultra-high performance liquid chromatography (UHPLC), allows the separation of all compounds (including isobaric pairs) in less than 4.1 min. The fast polarity switching mode of the triple quadrupole mass spectrometer used enables the registration of positive (phthalates) and negative (parabens and BPA) ions in the same acquisition run. A Response Surface Methodology was used for the optimization of the method. The optimum elution program starts with 0.2 min in isocratic conditions (79.8% water; 20% acetonitrile, 0.2% ammonium formate 5mM at pH 10.2), then the content of acetonitrile is linearly increased in 2 min up to 42%, and later up to 98% in 1.1 min. The analytical characteristics of the developed method were satisfactory. The method is robust and showed a linear response with determination coefficients (R(2)) higher than 0.991 in the range 5.0-2000 pg on column (or higher) for all the compounds investigated. Instrumental intra- and inter-day precision (expressed as relative standard deviation) were lower than 12% for parabens and bisphenol A, and between 5.9% and 27% for phthalates. Instrumental detection and quantification limits (iLODs and iLOQs) were in the range of medium-high femtograms (270-1300 pg on column for iLODs). Finally, the suitability of the developed method was demonstrated through its application to the analysis of commercial personal care products (shower gels) without any sample treatment, only a simple dilution, being possible to determine the simultaneous presence of phthalates, parabens, and bisphenol A in almost all the gels analyzed.

MATERIALIEN
Produktnummer
Marke
Produktbeschreibung

Sigma-Aldrich
Aceton, ACS reagent, ≥99.5%
Sigma-Aldrich
Methanol, ACS reagent, ≥99.8%
Sigma-Aldrich
Dichlormethan, contains 40-150 ppm amylene as stabilizer, ACS reagent, ≥99.5%
Sigma-Aldrich
Ameisensäure, reagent grade, ≥95%
Sigma-Aldrich
Acetonitril, ACS reagent, ≥99.5%
Sigma-Aldrich
Hexan, ReagentPlus®, ≥99%
Sigma-Aldrich
Dichlormethan, anhydrous, ≥99.8%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Ameisensäure, ACS reagent, ≥96%
Sigma-Aldrich
Acetonitril, anhydrous, 99.8%
Sigma-Aldrich
Methanol, anhydrous, 99.8%
Sigma-Aldrich
Ammoniak -Lösung, 7 N in methanol
Sigma-Aldrich
Ammoniumformat, reagent grade, 97%
Sigma-Aldrich
Methanol, Laboratory Reagent, ≥99.6%
Sigma-Aldrich
Ammoniumformat, ≥99.995% trace metals basis
Sigma-Aldrich
Ameisensäure, ACS reagent, ≥88%
Sigma-Aldrich
Dichlormethan, ACS reagent, ≥99.5%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Methanol, ACS spectrophotometric grade, ≥99.9%
Sigma-Aldrich
Hexan, Laboratory Reagent, ≥95%
Sigma-Aldrich
Methanol, ACS reagent, ≥99.8%
Sigma-Aldrich
Ammoniumformiat -Lösung, BioUltra, 10 M in H2O
Sigma-Aldrich
Aceton, ACS reagent, ≥99.5%
Supelco
4,4′-Isopropylidendiphenol, ≥99%
Sigma-Aldrich
Methanol, Absolute - Acetone free
Sigma-Aldrich
Ammoniak -Lösung, 2.0 M in ethanol
Sigma-Aldrich
Methanol, BioReagent, ≥99.93%
Sigma-Aldrich
Ammoniak, anhydrous, ≥99.98%
Sigma-Aldrich
Ammoniak -Lösung, 0.4 M in dioxane
Sigma-Aldrich
Ammoniak -Lösung, 4 M in methanol
Sigma-Aldrich
Aceton, histological grade, ≥99.5%
Sigma-Aldrich
Ammoniak -Lösung, 0.4 M in THF