Passa al contenuto
Merck
  • Fast and simultaneous determination of endocrine disrupting compounds by ultra-high performance liquid chromatography-tandem mass spectrometry.

Fast and simultaneous determination of endocrine disrupting compounds by ultra-high performance liquid chromatography-tandem mass spectrometry.

Talanta (2015-12-24)
C Esteve, L Herrero, B Gómara, J E Quintanilla-López
ABSTRACT

A rapid and sensitive analytical method for the simultaneous determination of thirteen endocrine disruptors (five phthalates, seven parabens, and bisphenol A) in a single chromatographic run has been developed for the first time. The separation method, based on ultra-high performance liquid chromatography (UHPLC), allows the separation of all compounds (including isobaric pairs) in less than 4.1 min. The fast polarity switching mode of the triple quadrupole mass spectrometer used enables the registration of positive (phthalates) and negative (parabens and BPA) ions in the same acquisition run. A Response Surface Methodology was used for the optimization of the method. The optimum elution program starts with 0.2 min in isocratic conditions (79.8% water; 20% acetonitrile, 0.2% ammonium formate 5mM at pH 10.2), then the content of acetonitrile is linearly increased in 2 min up to 42%, and later up to 98% in 1.1 min. The analytical characteristics of the developed method were satisfactory. The method is robust and showed a linear response with determination coefficients (R(2)) higher than 0.991 in the range 5.0-2000 pg on column (or higher) for all the compounds investigated. Instrumental intra- and inter-day precision (expressed as relative standard deviation) were lower than 12% for parabens and bisphenol A, and between 5.9% and 27% for phthalates. Instrumental detection and quantification limits (iLODs and iLOQs) were in the range of medium-high femtograms (270-1300 pg on column for iLODs). Finally, the suitability of the developed method was demonstrated through its application to the analysis of commercial personal care products (shower gels) without any sample treatment, only a simple dilution, being possible to determine the simultaneous presence of phthalates, parabens, and bisphenol A in almost all the gels analyzed.

MATERIALI
Numero di prodotto
Marchio
Descrizione del prodotto

Sigma-Aldrich
Acetone, ACS reagent, ≥99.5%
Sigma-Aldrich
Metanolo, ACS reagent, ≥99.8%
Sigma-Aldrich
Diclorometano, contains 40-150 ppm amylene as stabilizer, ACS reagent, ≥99.5%
Sigma-Aldrich
Acido formico, reagent grade, ≥95%
Sigma-Aldrich
Acetonitrile, ACS reagent, ≥99.5%
Sigma-Aldrich
Esano, ReagentPlus®, ≥99%
Sigma-Aldrich
Acido formico, ACS reagent, ≥96%
Sigma-Aldrich
Acetonitrile, anhydrous, 99.8%
Sigma-Aldrich
Ammoniaca, 7 N in methanol
Sigma-Aldrich
Formato di ammonio, reagent grade, 97%
Sigma-Aldrich
Metanolo, Laboratory Reagent, ≥99.6%
Sigma-Aldrich
Formato di ammonio, ≥99.995% trace metals basis
Sigma-Aldrich
Acido formico, ACS reagent, ≥88%
Sigma-Aldrich
Diclorometano, ACS reagent, ≥99.5%, contains 40-150 ppm amylene as stabilizer
Sigma-Aldrich
Metanolo, ACS spectrophotometric grade, ≥99.9%
Sigma-Aldrich
Esano, Laboratory Reagent, ≥95%
Sigma-Aldrich
Metanolo, ACS reagent, ≥99.8%
Sigma-Aldrich
Ammonium formate solution, BioUltra, 10 M in H2O
Sigma-Aldrich
Acetone, ACS reagent, ≥99.5%
Supelco
Bisphenol A, ≥99%
Sigma-Aldrich
Metanolo, Absolute - Acetone free
Sigma-Aldrich
Ammoniaca, 2.0 M in ethanol
Sigma-Aldrich
Metanolo, BioReagent, ≥99.93%
Sigma-Aldrich
Ammoniaca, 0.4 M in dioxane
Sigma-Aldrich
Ammoniaca, 4 M in methanol
Sigma-Aldrich
Acetone, histological grade, ≥99.5%
Sigma-Aldrich
Ammoniaca, 0.4 M in THF
Sigma-Aldrich
Acetonitrile, biotech. grade, ≥99.93%
Sigma-Aldrich
Acetonitrile, electronic grade, 99.999% trace metals basis
Sigma-Aldrich
Metanolo, ACS reagent, ≥99.8%