Passa al contenuto
Merck
  • Pharmaceutical properties of a low-substituted hydroxypropyl cellulose (L-HPC) hydrogel as a novel external dressing.

Pharmaceutical properties of a low-substituted hydroxypropyl cellulose (L-HPC) hydrogel as a novel external dressing.

International journal of pharmaceutics (2014-12-03)
Atsushi Ogawa, Sachie Nakayama, Mami Uehara, Yasuhiro Mori, Mai Takahashi, Tetsuya Aiba, Yuji Kurosaki
ABSTRACT

Controlling the moisture balance between exudates and their transpiration from the surface of wounded skin is important for healing. Low-substituted hydroxypropyl cellulose (L-HPC) hydrogel sheets (HGSs) possessing high water retention and water vapor transmission properties were prepared by neutralizing the highly viscous alkaline liquid of 7-10% L-HPC. Glycerol-impregnated L-HPC hydrogel sheets (L-HPC G-HGSs) were obtained by exchanging aqueous liquid in L-HPC HGSs. The physical characteristics required for wound dressings, i.e., mechanical strength, adhesive strength, and water retention properties, as well as the water vapor transmission (WVT) properties of L-HPC HGSs and L-HPC G-HGSs were evaluated. The mechanical strengths of L-HPC HGSs were enhanced with increases in the L-HPC content. The impregnation of glycerol in L-HPC HGSs yielded a significantly elasticated sheet. The adhesive strengths of L-HPC HGSs were significantly lower than those of commercial medical dressings. Water retention in L-HPC HGSs after being stored for 2h at 37°C was approximately 50%. The WVT rate of 7% L-HPC HGS was approximately 40g/m(2)/h, which was markedly higher than that of silicone gel type medical dressings. In conclusion, L-HPC HGSs are promising dressings that maintain an adequate moisture balance by transpiring excessive wound exudates with less damage to the healing wound.

MATERIALI
Numero di prodotto
Marchio
Descrizione del prodotto

Sigma-Aldrich
Acido cloridrico, ACS reagent, 37%
Sigma-Aldrich
Glicerolo, ACS reagent, ≥99.5%
Sigma-Aldrich
Sodio idrossido, ACS reagent, ≥97.0%, pellets
Sigma-Aldrich
Glicerolo, Molecular Biology, ≥99.0%
Sigma-Aldrich
Glicerolo, ReagentPlus®, ≥99.0% (GC)
Sigma-Aldrich
Sodio idrossido, reagent grade, ≥98%, pellets (anhydrous)
Sigma-Aldrich
Idrossido di sodio, 50% in H2O
Sigma-Aldrich
Acido cloridrico, ACS reagent, 37%
Sigma-Aldrich
Cloruro di idrogeno, 4.0 M in dioxane
Sigma-Aldrich
Idrossido di sodio, BioUltra, Molecular Biology, 10 M in H2O
Sigma-Aldrich
Idrossido di sodio, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Acido cloridrico, 1.0 N, BioReagent, suitable for cell culture
Sigma-Aldrich
Sodio idrossido, BioXtra, ≥98% (acidimetric), pellets (anhydrous)
Sigma-Aldrich
Sodio idrossido, puriss., meets analytical specification of Ph. Eur., BP, NF, E524, 98-100.5%, pellets
Sigma-Aldrich
Acido cloridrico, 37 wt. % in H2O, 99.999% trace metals basis
Sigma-Aldrich
Glicerolo, ≥99.5%
Sigma-Aldrich
Cloruro di idrogeno, 2.0 M in diethyl ether
Sigma-Aldrich
Sodio idrossido, reagent grade, 97%, powder
Sigma-Aldrich
Glicerolo, 83.5-89.5% (T)
Sigma-Aldrich
Acido cloridrico, 36.5-38.0%, BioReagent, Molecular Biology
Sigma-Aldrich
Sodio idrossido, pellets, semiconductor grade, 99.99% trace metals basis
Sigma-Aldrich
Glicerolo, BioReagent, suitable for cell culture, suitable for insect cell culture, suitable for electrophoresis, ≥99% (GC)
Supelco
Acido cloridrico, volumetric, 0.1 M HCl (0.1N), endotoxin free
Sigma-Aldrich
Glicerolo, BioUltra, Molecular Biology, anhydrous, ≥99.5% (GC)
Supelco
Glicerolo, Pharmaceutical Secondary Standard; Certified Reference Material
Sigma-Aldrich
Idrossido di sodio, 5.0 M
Sigma-Aldrich
Glicerolo, BioXtra, ≥99% (GC)
Sigma-Aldrich
Sodio idrossido, beads, 16-60 mesh, reagent grade, 97%
USP
Glicerina, United States Pharmacopeia (USP) Reference Standard
Sigma-Aldrich
Sodio idrossido, reagent grade, 97%, flakes