Skip to Content
MilliporeSigma
  • Formation of fluorescent polydopamine dots from hydroxyl radical-induced degradation of polydopamine nanoparticles.

Formation of fluorescent polydopamine dots from hydroxyl radical-induced degradation of polydopamine nanoparticles.

Physical chemistry chemical physics : PCCP (2015-03-31)
Jia-Hui Lin, Cheng-Ju Yu, Ya-Chun Yang, Wei-Lung Tseng
ABSTRACT

This study describes the synthesis of fluorescent polydopamine dots (PDs) through hydroxyl radical-induced degradation of polydopamine nanoparticles. The decomposition of polydopamine nanoparticles to fluorescent PDs was confirmed using transmission electron microscopy and dark-field microscopy. The analysis of PDs by using laser desorption/ionization time-of-flight mass spectrometry revealed that the PDs consisted of dopamine, 5,6-dihydroxyindole, and trihydroxyindole units. Oligomerization and self-assembly of these units produced a broad adsorption band, resulting in an excitation-wavelength-dependent emission behavior. The maximal fluorescence of PDs appeared at 440 nm with a quantum yield of 1.2%. The coordination between the catechol groups of PDs and ferric ions (Fe(3+)) quenched the fluorescence of PDs; the limit of detection at a signal-to-noise ratio of 3 for Fe(3+) was determined to be 0.3 μM. The presence of pyrophosphate switched on the fluorescence of the PD-Fe(3+) complexes. Compared to the other reported methods for sensing Fe(3+), PDs provided simple, low-cost, and reusable detection of Fe(3+).

MATERIALS
Product Number
Brand
Product Description

Sigma-Aldrich
Hydrochloric acid solution, 0.01 M
Sigma-Aldrich
Hydrochloric acid solution, 0.5 M
Sigma-Aldrich
Hydrochloric acid solution, 0.2 M
Sigma-Aldrich
Tris(hydroxymethyl)aminomethane, ≥99.8%
Sigma-Aldrich
Hydrochloric acid solution, 0.02 M
Sigma-Aldrich
Sodium hydroxide solution, 0.01 M
Sigma-Aldrich
Hydrochloric acid solution, 1 M
Sigma-Aldrich
Sodium chloride solution, 1 M
Sigma-Aldrich
Potassium chloride solution, 0.01 M
Sigma-Aldrich
Sodium hydroxide solution, 0.1 M
Sigma-Aldrich
Tris(hydroxymethyl)aminomethane, JIS special grade, ≥99.0%
Sigma-Aldrich
Sodium chloride, JIS special grade, ≥99.5%
Sigma-Aldrich
Sodium hydroxide solution, 4 M
Sigma-Aldrich
Hydrogen chloride – ethanol solution, 0.1 M in ethanol
Sigma-Aldrich
Sodium hydroxide, JIS special grade, ≥96.0%
Sigma-Aldrich
Hydrochloric acid solution, 12 M
Sigma-Aldrich
Hydrochloric acid, JIS special grade, 35.0-37.0%
Sigma-Aldrich
Hydrochloric acid solution, 2 M
Sigma-Aldrich
Sodium chloride, SAJ first grade, ≥99.0%
Sigma-Aldrich
Hydrochloric acid, SAJ first grade, 35.0-37.0%
Sigma-Aldrich
Sodium hydroxide solution, 0.05 M
Sigma-Aldrich
Hydrogen chloride solution, 3 M in cyclopentyl methyl ether (CPME)
Sigma-Aldrich
Hydrochloric acid solution, 6 M
Sigma-Aldrich
Sodium hydroxide solution, 7 M
Sigma-Aldrich
Tris(hydroxymethyl)aminomethane, ≥99.8%
Sigma-Aldrich
Sodium hydroxide solution, 6 M
Sigma-Aldrich
Hydrochloric acid solution, 0.05 M
Sigma-Aldrich
Hydrogen peroxide solution, SAJ first grade, ≥30.0%
Sigma-Aldrich
Sodium hydroxide solution, 1 M
Sigma-Aldrich
Hydrogen peroxide solution, contains potassium stannate as inhibitor, 30-32 wt. % in water, semiconductor grade, 99.999% trace metals basis